To learn more about inductors and its working follow the link.Īir cored coils are good for low inductance coils, where interference is not of utmost importance. Toroidal, multi-aperture cores, pot, and other enclosed cores enclose the magnetic field inside the core, increasing efficiency and practically reducing interference to zero. Each core material should only be used inside of the specified frequency range, outside of which core starts exhibiting high losses. Different commonly used materials have different relative permeabilities, ranging from 4000 for electrical steel used in mains transformers, through around 300 for ferrites used in SMPS transformers and around 20 for iron powder cores used at VHF. The ratio of inductance after and before a core with the diameter of the coil has been inserted inside it is called relative permeability (denoted μ r). Winding a coil, over a ferromagnetic coil focuses the magnetic field, increasing the inductance. Air cores are the most broadband but getting high inductances means using a lot of wire, they are also not the most efficient do to the magnetic field escaping the coil – this escaping magnetic can cause interference by inducting in nearby wires and other coils. There are different methods of making coils, depending on the area of use and inductance needed.

Winding coils is not hard but quite time-consuming.

Every hobbyist wanting to dabble in radio has to – at some point – wind a coil or two, be it the antenna coil of an AM radio, a coil on a toroidal core for a bandpass filter in a communications transceiver or a centrally tapped coil for use in a hartley oscillator.

Ferrite inductor calculator